Kawasaki Ninja 300 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hey everyone! Loving the bike! I had a 2012 ninja 250r before this, and I bought a two brothers slip on for it. I sold it before I had the chance to install it. So naturally, I tried installing it on my 300. It didn't work :( Two bros said it would cost more to get another mid pipe and hardware than to get the new kit. Just wondering, has anyone tried doing this? Or should I sell the 250 kit and save up for the new one?
 

·
Registered
Joined
·
2,760 Posts
the mid pipe is a bit different but the output location is the same from what I can tell.. I installed the stock 300 exhaust on my 250R, all I needed to use was the rear peg from the 300 and it bolted right up..

Do you plan on keeping your rear pegs? If not maybe a 250R peg delete bracket would work or you could try a set of 250R rear pegs?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top