Can a mod be done to the rear sprocket to perform the same fucntion as adding one to the front?
Gearing
I love the new wider ratio trans, much better than the old 250 in both spread and shift action precision. However, the gearing on the 300 is very low in first, and I was using second gear most of the time from a dead stop. Even with a passenger it was better than first which was more noise than action IMO.
On went a 2008-12 15t counter shaft sprocket, fit perfectly and suddenly I have a useable first gear! Nice mod, and I'm a guy who runs super short gears on everything I own. My Mustang has 4.56s and my KTM 950 SMR had a -2 front CS so I like my peppy gearing.
Another +, I think the speedo will be closer to actual speed now, stock it runs higher than actual speed. I'll verify that with a GPS ASAP but so far I'm convinced it is actually dong the speed it is reading.
On went a 2008-12 15t counter shaft sprocket, fit perfectly and suddenly I have a useable first gear! Nice mod, and I'm a guy who runs super short gears on everything I own. My Mustang has 4.56s and my KTM 950 SMR had a -2 front CS so I like my peppy gearing.
Another +, I think the speedo will be closer to actual speed now, stock it runs higher than actual speed. I'll verify that with a GPS ASAP but so far I'm convinced it is actually dong the speed it is reading.
1 - 1 of 208 Posts
1 - 1 of 208 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Kawasaki Ninja 300 Forums
A forum community dedicated to Kawasaki Ninja 300 motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, and more!
Full Forum Listing
