Oki .. So I am slowly going crazy trying to find a Service Manual for this bike. I am trying to install my frame sliders and need to use my engine bolt, but need to know what to torque them back too.
Thanks .. ya my bf just found the instructions .. May actually get to ride it tonighthttp://www.ninjette.org/wiki/Fastener_Torque_Specifications
Found that. Doesn't the instruction have the specs? I did some search and found 51ft/lb as the spec for yoshi slider.
Divide by 12 and it will be ft lbs. Just a weaker torque spec. 1/4 inch drives use it.Thanks for the spec sheet tmd. I hope that the specs are the same for the 300. I have a torque wrench but its 1/2" drive was going to look for a 1/4 drive one and need to find the range I need but what the heck is 80 in•lb?