[Ninja300]

So I ordered a sheet of 3M Vinyl Wrap in Satin Black in order to break up the white on the bike (almost like the white 636). 4 1/2 hours later this is how it looks: ( tried to do all of the tail fairing in satin black but it was to hard due to the creases).




Sent from Motorcycle.com Free App

 

[Sebi]

That looks great!!!
How much did it end up costing you?

Next up, ya gotta get some HID's!

 

[Ninja300]

20 bucks for the wrap. I think I will either wait to an after market company creates the 3 remaining tail pieces of fairing in satin black or just order the black 300's pieces.


Sent from Motorcycle.com Free App

 

[fishdip]

I don't see what you did?

 

[Brother Michigan]

I don't see what you did?

That's how you know it's good.

 

[fishdip]

So just the one little strip? now the 4 1/2 was with messing around on the tail.

 

[Ninja300]

Under the seat it's satin black , I wanted to do the whole tail but to many curves, I like it, breaks up the white and separates the tank from the bike (color wise)


Sent from Motorcycle.com Free App

 

[Ninja300]

Yea I removed all pieces but it came out horrible, and then I gave it one last ditch attempt to put all the pieces back on and do it while the pieces were on the bike fail again lol. But at least the 2 pieces under the seat came out flawless



Sent from Motorcycle.com Free App

 

[gottheneed]

did you use a heat gun? I think with some patience and time you could get the tail wrapped too. Looks great so far.

 

[Ninja300]

Hair dryer and the curves bunched up no matter how much I pulled squeegeed and hit it with the hair dryer.


Sent from Motorcycle.com Free App

 

[Captain]

Hair dryer? Should try a heat gun. Might give you that extra leeway you need.


Sent from Motorcycle.com Free App

 

[cbzdel]

Looks good, i wad thinking about doing the same thing.. How hard was it to get down in the screw hole?

 

[Ninja300]

Not hard went right over it then punched a pen through it the screw covers any imperfection looks like it came factory


Sent from Motorcycle.com Free App

 

[cerasoli1188]

Looks good man, funny my buddy and I were talking about doing something like this today. lol

 

[Ninja300]

Thanks, I like the look but it was a pain to get the vinyl wrap perfect.


Sent from Motorcycle.com Free App

 

[Rekognize]

Do the whole bike!

 

[kenneth davidson]

I did this on my old bike yamaha dt175 and it really was difficult to do but once I got it right,it looked really good.but the colour faded after a few months of having the bike in the sun.

 

[cbzdel]

Yeah I just read online that satin and flat color vinyls do not last outside very long..

 

[Ninja300]

That's why I decided to do just the piece of fairing under the seat. When it fades I will peel it off.


Sent from Motorcycle.com Free App

 

[Ninja300]

Finally did the rear fairing!


Breaks up all the white


Sent from Motorcycle.com Free App